Installing a vinyl fence on a slope

Stepped fence is used when the ground of your yard has steeper grades. The stepped fence do not follow the slope of the land, and each section of the fence leaves a gap normally is a triangular shape between the bottom rail and ground. For this method, besides the post routing and rail notched connection, maybe the bracket connection system will be easier. For most slope ground, both racked fencing and stepped fencing are viable, before you choose, carefully consider which fencing styles work best for you and your family.

If you have any question, please feel free to leave us message, Showtech Fence are ready to help you choose and make suitable vinyl fence for you. Next: PVC pipe extrusion process. Refer to the maximum slope chart for various fence styles.

Posts must be closer together when measured with a level string line to attain even picket spacing at end of fence sections. Refer to the diagram and examples. Determine section rise by using line level and measuring vertical rise measure rise in inches.

Once you have determined the rise per foot or angle, refer to the hole enlargement size chart. For a steady sloping terrain, use end post or blank posts.

Mark posts and make holes on opposite side to allow rail alignment on both sides of posts. Determine hole size required. Mark hole cut out on post in correct location. Drill 4 holes in corners, same as radius required. Cut along straight lines with a saber saw. Gates on a vinyl fence can get a little tricky to install as they will not rake. Try and install them with the attached part on the higher side of the slope so that gate can hang from that side.

Just like it sounds, a stepped fence is when the sections of the fence step down every so often typically after each panel with an uneven rail that causes the outline of the fence to resemble stairs. Because of the shape of this fence, it leaves a triangular-shaped open space between the bottom rail and the ground.

This type of fence installation is more labor-intensive and typically used for yards with steeper grades. It is not suggested for families who are trying to contain children or pets because the gaps under the fence will provide space for them to escape.

Either you will need to trim down the length of the posts as you install the fence since they will be going down a little bit at a time as they go down the slope , or leave them as-is while you put them in and just cut them afterward. At the higher ground, keep the bottom rail as close to the ground as possible or even bury it a few inches in the ground.

This will help keep the gap as small as possible between the fence and the ground. Depending on your preference, you can even choose to fill in the gaps with soil or put something against the fence i.

Similar to a sloped fence, consider talking to a fence contractor or consultant if your slope is greater than 15 degrees. Be sure to first measure and mark where you want to cut before you actually cut anything.

And keep in mind that vinyl fence posts usually go deeper into the ground than other fences. It would be much easier to cut your posts and rails before they are in the ground. Cut the vinyl with a circular saw, one with a sharp, fine-tooth blade preferably made with carbide tips.

If the blade you have is meant for cutting wood and is rather dull, it can shatter your vinyl. If your vinyl is cold it can also have a bad effect on the fence and saw if you try to cut it. To prevent this, hold the vinyl steady, and be sure to keep your hands away from the blade of the saw. Take your time cutting it.

Putting up a vinyl fence on a slope is not meant to be a one-person project so please consider getting at least one other person to help you.

We at Fence Frenzy absolutely love taking on the challenge of building, or even restoring, a fence. Especially elaborate and exotic fence designs that really make us scratch our heads!